Rich,
I screwed up. I programmed the C02 firmware into the 6502 area and the 02 firmware into the 65C02 area. When I try and boot from slot 1, all I get is an * prompt. Moved the card to slot 7, and programmed it correctly. Move it back to slot 1 and asterisk prompt. Any way to recover ?
Reversed the eeprom programing
Moderator: rich
3 posts
• Page 1 of 1
Reversed the eeprom programing
by Ken C » Mon Aug 04, 2008 2:43 pm
- Ken C
- Posts: 12
- Joined: Thu Jul 24, 2008 5:32 pm
Re: Reversed the eeprom programing
by Ken C » Mon Aug 04, 2008 2:50 pm
Ok, I must have REALLY messed this card up. Now, the * prompt in slot 7 as well. Basically, no CFFA card. Hopefully, there is a recovery procedure ???
- Ken C
- Posts: 12
- Joined: Thu Jul 24, 2008 5:32 pm
Re: Reversed the eeprom programing
by Ken C » Thu Aug 07, 2008 12:55 pm
Thank you, Rich, all is working !
It took some serious help from Rich to get this bad boy working again. But, with his guidance, the CFFA card is functioning properly with Version 2 firmware.
And, the lesson learned, RTFM. Pay attention to what you are doing. My excuse ??? A senior moment, that's my story and I'm sticking to it. :-)
Once more, appreciate all your help.
Ken C
It took some serious help from Rich to get this bad boy working again. But, with his guidance, the CFFA card is functioning properly with Version 2 firmware.
And, the lesson learned, RTFM. Pay attention to what you are doing. My excuse ??? A senior moment, that's my story and I'm sticking to it. :-)
Once more, appreciate all your help.
Ken C
- Ken C
- Posts: 12
- Joined: Thu Jul 24, 2008 5:32 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests